Blue Ox BedSaver BXR4102 Operator And Installation Manual

Blue Ox BedSaver BXR4102 Operator And Installation Manual

Reese/drawtite 18k, 20k, 22k

Advertisement

Operator and Installation Manual
Reese/Drawtite 18K, 20K, 22K
Unless otherwise specified, the bedsaver will
NOT work with aftermarket pin boxes. See fit list.
TO BE VALID, THE WARRANTY CARD MUST BE COMPLETED IN ITS ENTIRETY BY AN
DISTRIBUTOR OR DEALER AND SENT TO AUTOMATIC EQUIPMENT MFG. CO., PENDER,
NEBRASKA OR REGISTERED ONLINE AT www.blueox.us.
FAILURE TO DO SO WILL VOID THE WARRANTY.
© 2005, 08, 10 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road,
Industrial Park
Pender, Nebraska 68047 • Phone 402-385-3051 • Fax 402-385-3360 •
www.blueox.com
BedSaver
BXR4102
AUTHORIZED
Page 1 of 6
292-2682 Rev E
Serial No.
TM
09/26/11
TM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BedSaver BXR4102 and is the answer not in the manual?

Questions and answers

Summary of Contents for Blue Ox BedSaver BXR4102

  • Page 1 DISTRIBUTOR OR DEALER AND SENT TO AUTOMATIC EQUIPMENT MFG. CO., PENDER, NEBRASKA OR REGISTERED ONLINE AT www.blueox.us. FAILURE TO DO SO WILL VOID THE WARRANTY. © 2005, 08, 10 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, • Industrial Park Pender, Nebraska 68047 •...
  • Page 2 It is assumed that you have the Reese or DrawTite 18K, 20K or 22K hitch installed properly. If not, have your hitch installed by a certified technician. © 2005, 08, 10 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, •...
  • Page 3 This procedure remains the same for your Drawtite hitch. For this procedure, consider the Reese and DrawTite hitches to be the same. Any differences will be © 2005, 08, 10 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, •...
  • Page 4 WARNING: The hitch head is very heavy and can cause serious injury if not lifted properly. To avoid personal injury, have a helper assist with this lift, and the subsequent reinstallation. © 2005, 08, 10 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, • Industrial Park Pender, Nebraska 68047 •...
  • Page 5 Place the Right Side Plate on the two right hand bolts protruding from the hitch frame and secure loosely with two Nylok nuts supplied in the kit. Do not tighten the nuts. © 2005, 08, 10 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, •...
  • Page 6 Again inspect the installation and compare against Figures 8-10. Your BedSaver installation should look very similar to these figures. © 2005, 08, 10 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, • Industrial Park Pender, Nebraska 68047 • Phone 402-385-3051 • Fax 402-385-3360 •...

Table of Contents