Table of Contents
Advertisement
After installing the second driver, run the PROIO_UPD.bat
again.
You are asked for the COM port. Now you can enter the
number, probably you get an error message, that the port
cannot be opened, but after a few seconds you should get
this window.
5.2 USB-Update
Once both drivers are installed, all Updates can be carried out
in a short time via the USB interface. You will only be asked for
the COM port number and after you entered it, the ProI/O will
be recorded in a few seconds with the new firmware.
Because this procedure is a little bit complicated, we have
implemented a network boot loader. You can run updates via
the network by using the configurator software. This software is
also part of the attached .zip file.
All ProI/O devices after the software version 1.15 come with
the installed boot-loader and can use this network upgrade.
USB-update and driver installation
23
Advertisement
Table of Contents
