Preparation Process - Barco UDX Series Installation Manual

Installation process

2.1 Preparation process

Prepare for installation
1. Ensure that you understand all safety topics described in the chapter "Safety information", page 7.
2. Check if all installation requirements are fulfilled such as:
• the environmental conditions of the installation area,
• the electrical facilities,
• cooling requirements,
• the capabilities of the supporting structure (table/ceiling)
• etc ... for more info see chapter "Installation requirements", page 30.
3. Unpack the projector or pull out the projector from its flight case. See chapter "Unpacking the projector", page
32 or see chapter "UDX flight case", page 68.
4. In case of a first install perform an initial inspection of the projector. See chapter "Initial inspection", page 34.
5. Define the installation position of the projector. For detailed info and possibilities see chapters:
• "Projector orientations", page 35.
• "Projector positioning", page 37.
• "Projector shift and tilt range", page 38.
6. Select the lens that will best fit for the application. See chapter "Lens selection", page 39, and "Available
lenses", page 40.
24 R5906113 /09 UDX