Eu Declaration Of Conformity - V2 SIRMO-DIGIT Manual

Digital radio or wired switch

Hide thumbs Also See for SIRMO-DIGIT:

Manual (21 pages)

Table of Contents

4. DIP-SWITCH CODE (only version

Royal/53200)

The factory dip-switch code set for channel 1 is 0101010101 00.

If other remote controls are already stored on the receiver, the dip-

switch code of the keypad has to be set with the same sequence

of the one set on the dip-switch of the remote control.

The dip-switch of the remote control is made up by a series of 12

micro switches set to ON or OFF.

To set the same code on the keypad, it is necessary to key in a

code made up of 12 digits: those will be 0 or 1, depending on the

position of the micro switches on the remote control

- micro switch set to ON = 1

- micro switch set to OFF= 0

If the transmitter is single channel, the dip-switch to be set

coincides with the position of the 12 micro switches.

If the transmitter is two-channel and the key stored is 2, the

dip-switch code to be set coincides with the position of the 12

micro switches. If the key stored on the receiver is the key 1, the

dip-switch code coincides with the position of the micro switches

from 1 to 10 plus the 2 digit 00.

If the transmitter is four-channel, the dip-switch code to be

set coincides with the position of the micro switches from 1 to 10

plus 2 digits, which are:

• 00 if the key stored on the receiver is the key 1

(e.g. 1010101010 00)

• 10 if the key stored on the receiver is the key 2

(e.g. 1010101010 10)

• 01 if the key stored on the receiver is the key 3

(e.g. 1010101010 01)

• 11 if the key stored on the receiver is the key 4

(e.g. 1010101010 11)

If no transmitter has been stored on the receiver, the

dip-switch code can be set entering a random sequence of 12

digits 0 or 1.

OPERATIONS TO BE MADE ON THE KEYPAD

1. Key in # + PROGRAMMING CODE + #

Signalling: 1 BEEP of 1,5 sec. + L1 and L2 on for 1,5 sec.

2. Key in within a minute the KEY 4 + #

Signalling: 4 BEEPs + L1 and L2 flashing alternately

3. Key in the NUMBER OF THE CHOSEN CHANNEL + #

Signalling: 1 BEEP of 1 sec. + L1 and L2 flashing alternately

4. Key in the CHOSEN DIP-SWITCH CODE + #

Micro switch set to ON = 1

Micro switch set to OFF = 0

Signalling:

- 1 BEEP of 3 sec. + L1 and L2 on if the

operation is correct;

- short flashes of the LED if incorrect