Page 1
User Manual —————————————— HDMI Matrix ---HDMI1616 Dear Customer Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference.
Production Specification Important Safety Instructions ◆Make sure that all devices you will be connecting up are properly grounded. ◆Make sure that the power to all the devices you will be connecting up has been turned off. ◆Do not place other objects on the cable. ◆Risk of electrical shock, do not open.
Main Unit IR Remote Control Power Cord Serial Port Line Inspect Certificate Guarantee Card Hardware Installation 1. Connect HDMI source (such as a PC with HDMI port) to the HDMI1616. 2. Connect HDMI sink to HDMI1616. 3. Power on all the devices.
Production Specification 4. Use the remote to control the matrix, or using front panel, PC software control、 RS485、 WIFI (Option) and RS232 to control. Product Appearance Front Panel Overview Pic 1 Item Description LCD Screen display the current status and Input-to-Output display relationships Power State Power LED Light IR Sensor...
Production Specification Rear Overview Pic 2 Item Description Power Turns on/off the device Ground Connect to the Ground Input Channel Connect to the source Output Channel Connect to the sink RS485 RS485 port, control the matrix RS232-IN(Female) Female(Connected to the computer, control the matrix) Male RS232-OUT(Male)...
Production Specification Pic 3 Switch MENU As shown in the following figure, it means that the input port 1 switches to output 1 port. Pic 4 Menu Description Press the MENU button on the front panel, the main menu will appear, including five submenus. Pic 5 1.
Page 8
Production Specification Pic 8 2. View EQ&SW Unused for Matrix16*16 3. Set FAN &Buzzer Unused for Matrix16*16 4. System Set System reset and display off time setting, press 4 to select the submenu, as shown below Pic 9 1) 、 Press 0 to enter the factory settings interface, as shown below Pic10 2)...
Production Specification Pic 12 3)、IP Address is not available, need to have hardware available Remote Controller Pic 13 Item Button Function POWER Turns on/off the display screen LOCK Disable CTRL Disable SAVE Save current Matrix plan LOAD Calling set Matrix plan Select all the output ports to be configured simultaneously with the same setting Disable...
Production Specification OUTPUT BUTTON selecting the numbered output port to be configured INPUT BUTTON selecting the numbered input port to be configured ENTER Confirm your operation Cancel the last operation MENU The menu key contains 5 submenus EDID Operation The matrix has two ways to read the EDID. The factory default setting automatic read mode. Automatically read EDID.
Production Specification 3) 、R x-PC mode Press the input bar 3, then select Rx-PC mode. EDID information at this time by the PC-side host software specified( Specific steps see PC software instructions). 4) 、 4K mode Press the input bar 4, then select 4K mode. 5)...
Page 12
Production Specification Pic 17 Pic 18 RS-232 port IN (D-SUB9F) functional description Functional RS-232 port OUT (D-SUB9M) functional description Functional ---(RXD)...
1.Check that the AC power cord is plugged into an electrical outlet and that the switch is on. No image 1. Verify that the input source is powered on and connected to the HDMI1616 matrix switcher. 2. To confirm whether the display device is turned on and connected with the HDMI1616 matrix switch intact.
Need help?
Do you have a question about the HDMI1616 and is the answer not in the manual?
Questions and answers