Keyestudio ARDUINO maker learning kit Manual page 128

LcdDataWrite(' ');
LcdDataWrite('h');
LcdDataWrite('o');
LcdDataWrite('n');
LcdDataWrite('g');
LcdDataWrite('y');
LcdDataWrite('i');
delay(3000);
LcdCommandWrite(0x02); // set mode as new characters replay old ones, where there is no new
ones remain the same
delay(10);
LcdCommandWrite(0x80+5); // set cursor position at first line, sixth position
delay(10);
LcdDataWrite('t');
LcdDataWrite('h');
LcdDataWrite('e');
LcdDataWrite(' ');
LcdDataWrite('a');
LcdDataWrite('d');
LcdDataWrite('m');
LcdDataWrite('i');
LcdDataWrite('n');
delay(5000);
}
//////////////////////////////////////////////////////////
4-bit connection method:
When using this module, 8-bit connection uses all the digital pins of the Arduino, leaving no pin
for sensors. What then? We can use 4-bit connection.
Connection circuit:
Connection for R3:
keyestudio
www.keyestudio.cc
126