Table of Contents
Advertisement
DT5-1125 V1 – UserManual
Specifications subject to change without notice. | USA 140916 | Page 16 of 16
11 Part Disposal
Since August 2005 there are EC-wide directives defined in the EC Directive 2002/96/EC and in national codes
concerning the waste electrical and electronic equipment and also regarding this device.
For private households there are special collecting and recycling possibilities. For this device isn't registered for the
use in private households, it mustn't be disposed this way. You can send it back to your national sales organisation
for disposal. If there are any questions concerning disposal please contact your national sales organisation.
Outside the EC, you have to consider the corresponding directives.
12 Notes and General Information
It is important to read this user manual thoroughly and clearly in order to understand the information and
®
instructions. The PolyGard
transmitters must be used within product specification capabilities. The appropriate
operating and maintenance instructions and recommendations must be strictly followed.
Due to on-going product development, MSR-Electronic-GmbH and INTEC Controls reserve the right to change
specifications without notice. The information contained herein is based upon data considered to be accurate.
However, no guarantee is expressed or implied regarding the accuracy of these data.
12.1 Intended Product Application
®
The PolyGard
NH
transmitters are designed and manufactured for control applications and air quality compliance
3
in commercial buildings and manufacturing plants.
12.2 Installers' Responsibilities
®
It is the installer's responsibility to ensure that all PolyGard
transmitters are installed in compliance with all national
and local codes and OSHA requirements. Installation should be implemented only by technicians familiar with
proper installation techniques and with codes, standards and proper safety procedures for control installations and
the latest edition of the National Electrical Code (ANSI/NFPA70). It is also essential to follow strictly all instructions
as provided in the user manual.
12.3 Maintenance
®
It is recommended to check the PolyGard
transmitter regularly. Due to regular maintenance any deterioration of
performance may easily be corrected. Re-calibration and part replacement may be implemented in the field by a
qualified technician and with the appropriate tools. Alternatively, the easily removable plug-in transmitter card with
the sensor may be returned for service to INTEC Controls.
12.4 Limited Warranty
®
MSR-Electronic-GmbH and INTEC Controls warrant the PolyGard
transmitters for (2) years from the date of
shipment against defects in material or workmanship and 12 months normal exposure for sensor element. Should
any evidence of defects in material or workmanship occur during the warranty period, MSR-Electronic-GmbH or
INTEC Controls will repair or replace the product at their own discretion, without charge.
This warranty does not apply to units that have been altered, had attempted repair, or been subject to abuse,
accidental or otherwise. The warranty also does not apply to units in which the sensor element has been
overexposed or gas poisoned. The above warranty is in lieu of all other express warranties, obligations or liabilities.
®
This warranty applies only to the PolyGard
transmitters. MSR-Electronic-GmbH and INTEC Controls shall not be
®
liable for any incidental or consequential damages arising out of or related to the use of the PolyGard
transmitters.
If the PolyGard® transmitter needs to be returned to INTEC Controls for service, an RMA number must be obtained
prior to sending.
PolyGard
is a registered trademark of MSR-Electronic GmbH | GAADT231125_E
®
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Advertisement
Table of Contents
