Specifications Subject To Change Without Notice. | Gaadt531193_E_1011 | Usa 200211 | Page 13 Of 13; Specifications Subject To Change Without Notice. | Usa 140403 | Page 13 Of 13; Specifications Subject To Change Without Notice. | Usa 160104 | Page 13 Of 13; Part Disposal - Intec Controls MSR ELECTRONIC PolyGard AT-1193 User Manual

PolyGard CL Gas Transmitter
®
2
AT-1193 V3 – UserManual
AT-1193 – UserManual AT-1193 – UserManual
User Manual - AT-1193

Specifications subject to change without notice. | GAADT531193_E_1011 | USA 200211 | Page 13 of 13

11 Part Disposal

Since August 2005 there are EC-wide directives defined in the EC Directive 2002/96/EC and in national
codes concerning the waste electrical and electronic equipment and also regarding this device.
For private households there are special collecting and recycling possibilities. For this device isn't registered
for the use in private households, it mustn't be disposed this way. You can send it back to your national
sales organization for disposal. If there are any questions concerning disposal please contact your
national sales organization.
Outside the EC, you have to consider the corresponding directives.

12 Notes and General Information

It is important to read this user manual thoroughly and clearly in order to understand the information
and instructions. The PolyGard
appropriate operating and maintenance instructions and recommendations must be followed.
Due to on-going product development, MSR and INTEC Controls reserve the right to change
specifications without notice. The information contained herein is based upon data considered to be
accurate. However, no guarantee is expressed or implied regarding the accuracy of this data.

12.1 Intended Product Application

®
The PolyGard Cl
2
compliance in commercial buildings and manufacturing plants.

12.2 Installers' Responsibilities

It is the installer's responsibility to ensure that all PolyGard
all national and local codes and OSHA requirements. Installation should be implemented only by
technicians familiar with proper installation techniques and with codes, standards and proper safety
procedures for control installations and the latest edition of the National Electrical Code (ANSI/NFPA70). It
is also essential to follow strictly all instructions as provided in the user manual.

12.3 Maintenance

It is recommended to check the PolyGard
performance deviations may easily be corrected. Re-calibration and part replacement in the field may be
implemented by a qualified technician and with the appropriate tools. Alternatively, the easily removable
plug-in transmitter card with the sensor may be returned for service to INTEC Controls.

12.4 Limited Warranty

MSR-Electronic-GmbH and INTEC Controls warrants the PolyGard
from the date of shipment against defects in material or workmanship and 12 months normal exposure for
sensor element. Should any evidence of defects in material or workmanship occur during the warranty
period, INTEC Controls will repair or replace the product at their own discretion, without charge.
This warranty does not apply to units that have been altered, had attempted repair, or been subject to
abuse, accidental or otherwise. The warranty also does not apply to units in which the sensor element
has been overexposed or gas poisoned. The above warranty is in lieu of all other express warranties,
obligations or liabilities.
This warranty applies only to the PolyGard
shall not be liable for any incidental or consequential damages arising out of or related to the use of the
®
PolyGard transmitters.
If the PolyGard® transmitter needs to be returned to INTEC Controls for service, an RMA number must be
obtained prior to sending.
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064

Specifications subject to change without notice. | USA 160104 | Page 13 of 13

Specifications subject to change without notice. | USA 140403 | Page 13 of 13

®
transmitters must be used within product specification capabilities. The
transmitters are designed and manufactured for control applications and air quality
Fax (858) 578-4633 & (888) FX INTEC
®
transmitters are installed in compliance with
®
transmitter regularly. Due to regular maintenance any
®
transmitters for a period of (2) years
®
transmitter. MSR-Electronic-GmbH and INTEC Controls
PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT531193_E_1011 Polygard® is a registered trademark of MSR | GAADT531193_E_1011.pdf
®
www.inteccontrols.com
Page 13
GAADT531193_E_1011.pdf
Specification subject to change without notice.
Printed in USA 140403