AT-3300_V3 – UserManual Page 03 Specifications subject to change without notice. | USA 151203 | Page 3 of 14 Transmitter with cathalytic bead sensor for combustible gases and vapours 1 Intended Use The PolyGard gas transmitter with digital processing of the measuring values and temperature compensation is used for the continuous monitoring of the ambient air to detect the presence of combustible gases and vapours, such as natural gas, methane, propane, butane and ammonia etc.
AT-3300_V3 – UserManual Page 04 Specifications subject to change without notice. | USA 151203 | Page 4 of 14 Certain substances and gases in the monitored ambient can affect the sensitivity of the sensor, or poison the sensor completely. The following are currently known: - polymerising substances, such as ethylene oxide, acrylonitrile, butadiene, styrene, silicone.
AT-3300_V3 – UserManual Page 05 Specifications subject to change without notice. | USA 151203 | Page 5 of 14 4 Electrical Connection Consider static electricity! See 3. Mounting • Installation of the electrical wiring should only be performed by a trained specialist according to the connection diagram, without any power applied to conductors and according to the corresponding regulations! •...
AT-3300_V3 – UserManual Page 06 Specifications subject to change without notice. | USA 151203 | Page 6 of 14 5.1 Calibration Depending on the version and the control mode there are three different possibilities to calibrate the transmitter: 5.1 Manual Calibration 5.1.1 Zero-point •...
AT-3300_V3 – UserManual Specifications subject to change without notice. | USA 151203 | Page 7 of 14 Example: Measuring range 100 % LEL Test gas concentration 40 % LEL (methane) Control voltage: Signal start 2 V / 4 mA 104 mV Control voltage: Signal start 0 V / 0 mA 80 mV Signal start 2 V / 4 mA...
AT-3300_V3 – UserManual Page 08 Specifications subject to change without notice. | USA 151203 | Page 8 of 14 5.3 Option Relay Output The two relays are activated in dependence of the gas concentration. If the gas concentration exceeds the adjusted alarm threshold, the corresponding relay switches on.
AT-3300_V3 – UserManual Page 09 Specifications subject to change without notice. | USA 151203 | Page 9 of 14 6 Inspection and Service 6.1 Inspections Inspection, service and calibration of the transmitters should be done by trained technicians and executed at regular intervals.
AT-3300_V3 – UserManual Page 10 Specifications subject to change without notice. | USA 151203 | Page 10 of 14 8 Technical Data General sensor performances Gas type Combustible gases/ vapours See Ordering Information Sensor element Ex sensor, catalytic bead Pressure range Atmosphere ±...
PolyGard transmitter. ® If the PolyGard® transmitter needs to be returned to INTEC Controls for service, an RMA number must be obtained prior to sending. Polygard® is a registered trademark of MSR | AT-3300_V3_UserManual 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 &...