Table of Contents
Advertisement
Quick Links
PolyGard
DT5-1125 V1
Electrochemical Ammonia Transmitter
Serial No. AT03-005
User Manual
December 2013
September 16, 2014 – Revision
PolyGard
is a registered trademark of MSR-Electronic GmbH | GAADT231125_E
®
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Intec Controls PolyGard DT5-1125 V1
Summary of Contents for Intec Controls PolyGard DT5-1125 V1
- Page 1 User Manual December 2013 September 16, 2014 – Revision PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com...
-
Page 2: Table Of Contents
Maintenance ......................... 16 12.4 Limited Warranty ........................16 PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 3: Intended Use
PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 4: Installation
When the PBC is mounted, it is important to ensure that the wire shields or any bare wires do not short the PCB. PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 5: Wiring Connection
10 sec. cancels the release of the correction function. PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 6: Calibration
30 %. Then the sensor has to be replaced. PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 7: Calculation Of Control Voltage
Further information can be taken from the user manual of the DGC5 Configuration and Calibration Software. PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 8: Addressing, Only For Dgc5_Bus Mode
Alarm threshold 2 = Relay 2: 250 ppm Switching hysteresis: 15 ppm PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 9: Service And Inspection
Plug in carefully the PCB into terminal block X4, X5. Calibrate according to section 5. PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 10: Troubleshooting
Jumper V-A not set Set the jumper. Remove it after calibration! PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 11: Cross-Sensitivity Data
< 2 (MB 100); 0 (MB 300) Nitrogen dioxide 20 ppm PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... -
Page 12: Technical Data
Current signal ca. 500 m (1500 ft.) Voltage signal ca. 200 m (500 ft.) PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... - Page 13 24 VAC/DC depending on the power supply max. load 50 mA PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com...
-
Page 14: Figures
- Two- or three-wire connection, depending on transmitter type PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com... - Page 15 2 – 10 V Calibration adapter Fig. 5 Type: CONKIT-E/CH-LC PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com...
-
Page 16: Part Disposal
If the PolyGard® transmitter needs to be returned to INTEC Controls for service, an RMA number must be obtained prior to sending. PolyGard is a registered trademark of MSR-Electronic GmbH | GAADT231125_E ® INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com...
Need help?
Do you have a question about the PolyGard DT5-1125 V1 and is the answer not in the manual?
Questions and answers