Advertisement
Ezairo® 7111 Pre Suite Getting Started Guide
3.4 Connecting the Programming Box
The programming box is connected to the Hybrid Demonstrator Board via the 6-pin DIN connector provided on the
Hybrid Demonstrator Board. The programming box connection is either a similar 6-pin DIN connector, or in the case of
the Promira, a 34-pin header adapter.
Next, connect the programming box to the PC using a USB cable. The fully connected system appears as shown in
Figure 6.
Figure 6. Connected Ezairo 7111 Hybrid Demonstrator Board, Windows PC, and Programming Box
Once the system is connected, you can perform the initial communication from the PC to Ezairo 7111 (device
connection).
4. W
S
ORKING WITH THE
OUND
4.1 Connect to Device
NOTE: The Ezairo Pre Suite firmware bundles are embedded within the Sound Designer Software.
Options for selecting the appropriate firmware are provided upon initial connection to a device.
To establish a connection with the device, follow these steps:
1.
Power on your device by plugging in the programming box and moving the Hybrid Demonstrator Board
ON-OFF switch to the ON position (if not already done).
ON Semiconductor Confidential
D
SDK
ESIGNER
www.onsemi.com
10
Advertisement
