Table of Contents
Advertisement
Lambda Labs - Professional Acoustics
PART
DESCRIPTION of 6.1 Figure 1
a)
ON/OFF Switch
ON/OFF Switch to switch the amplifier on and off. Push the button inwards to
switch the amplifier on and off.
Phase OK LEDs
b)
Status indicators, indicating that (correct) voltage is applied to the connector.
c)
Fault LED
Status indicator, indicating a function fault.
d)
Input Signal Attenuators
Rotary control to adjust the signal level for the respective channel.
e)
Level Meter LEDs
Status indicators, indicating signal levels and limits.
6.2. User Interface Detailed Description
6.2.1. ON/OFF Switch
You can switch the KW-18 power amplifier on and off using this front panel switch. If the unit is switched on, the white ring
on the ON/OFF Switch will be illuminated!
Caution: Always check the „Phase OK" and the „Fault" LEDs status when switching the unit on! If one
or more „Phase OK" LEDs are not illuminated, please check the power connection, and the
corresponding power input's voltage! For more information please refer to Chapter 5.1 Power
[
CAUTION!
Connection section of this manual!
Attention: Neutrik PowerCON is a connector without breaking capacity, therefore the PowerCON
should not be connected or disconnected under load or live!
[
ATTENTION!
Attention: Independent from the ON/OFF Switch's status, the unit will not switch on when there is not
at least two power input used with the correct voltage or if there is a fault in the KW-18 unit. In the
case of a fault, the „Fault" LED is illuminated!
[
ATTENTION!
www.lambda-labs.com
! 1 5
KW-18 Amplifier Manual
REFERENCE
Chapter 6.2.1
Chapter 6.2.2
Chapter 6.2.3
Chapter 6.2.4
Chapter 6.2.5
Advertisement
Table of Contents
