Advertisement
efficiency, the pot diameter should be the same as that of the plate. This is not always possible but,
in the interest of fuel economy, using very small or large pots should be avoided.
Spillage should never be allowed to accumulate around the edge of a plate as this will burn on and
become difficult to remove.
Cleaning a Boiling Top
Allow the unit to cool before cleaning.
Use a detergent/water solution, take care to rinse and dry all surfaces thoroughly. Stubborn stains
may be removed with a soap-filled pad. Be careful, NEVER use a harsh abrasive on stainless steel.
SECTION 4 - SERVICING
SERVICE ACCESS
Base Plate
Upturn unit and rest it at the edge of a worksurface with rear upstand overhanging the edge.
Undo base plate fixings to remove base plate.
FUNCTIONAL COMPONENTS
Control Switch
Remove base.
Remove control knob.
Remove electrical connections, noting their positions.
Undo fixings which secure control to panel and remove.
Replace in reverse order.
Elements
Remove base plate.
Undo electrical connections, noting their positions.
Undo element fixings and remove.
Replace in reverse order.
Terminal Block
Remove base plate.
Remove electrical connections at terminal block, noting their positions.
Undo fixings which secure the block to the unit and remove.
Replace in reverse order.
Neons
Remove base plate.
Remove electrical connections at terminal block, noting their positions.
Remove and replace neon.
Replace in reverse order.
Cable
Remove base plate.
Undo mains cable cord grip at unit rear.
Undo electrical connections at terminal block and remove cable.
Replace in reverse order. Ensure cable is fed through the securing clamp and pulled taut before
tightening the clamp.
Advertisement
