Advertisement
LD2 Boiling Top
This model is designed to be connected to a single phase AC supply. Electrical supply must be
installed using a suitable isolating switch with a minimum contact separation of 3mm in all poles.
SECTION 3 - USE and CLEANING
IMPORTANT: GENERAL NOTES ON CLEANING
Disconnect unit from electricity supply prior to cleaning.
Never use a coarse abrasive to clean exterior panels. A soft cloth with a warm
water and detergent solution is sufficient.
Never attempt to steam clean or hose down with a jet of water.
Plate Control Switch
Each hotplate is controlled by a switch which offers six individual heat settings. The LD2 front plates
have a built-in cut-out device to automatically reduce heat if the plates are left uncovered at a high
setting. Always switch plate settings to OFF position when not in use.
Rear to left Front to right
Rear
LH Front
For efficient operation, it is important that good contact be established between the plate and
utensil. Ground based pots should be used and the plate surface must be clean. For maximum
Figure 2 - LD1 Model
LH Rear
RH Rear
Figure 3 - LD2 Model
Front
RH Front
Advertisement
