Table of Contents
Advertisement
Coupling Hoses to Pump
The hoses from the hydraulic beam assembly
are connected to pump in the box. Slide hoses
through holes located on the side of the box.
Before connecting the hoses, clean dirt and
debris from connections. Debris in the pump
will cause the pump to fail. To attach the
hoses, pull back on the female coupler and
insert the male coupler. Once the couplers are
connected together properly, the two couplers
should lock together.
Always wear eye protection and heavy
gloves when connecting and disconnecting
hydraulic hoses to prevent high pressure
fluid spray from penetrating the skin.
Securing Hoses and Cords
The hydraulic hoses must be secured away from the moving
parts of the lift. A simple way to secure the hoses is with plas-
tic cable ties. Using the ties, the hoses can be attached to the
canopy frame.
Battery Hook-Up
The battery is not supplied with the hydraulic system. A 12-
volt deep-cycle marine battery is reccomended with dimen-
sions 6-1/2" x 10" x 8". The installation of the battery into the
box will be easier if the battery is the recommended
dimensions. Manuver the battery into the end of the black box
and attach the battery cables.
RED IS POSITIVE ( + )
System Shut-Off Switch
The hydraulic system is equipped with a shut-off switch.
The remote could operate your lift from a great distance.
To prevent accidental usage by children who find the
remote, use the system shut-off switch to disable the sys-
tem when not in use. The switch has a green knob and is
connected to the battery.
Tighten knob down clockwise to operate the lift.
Loosen knob up counterclockwise to shut-off the system.
BLACK IS NEGATIVE ( - )
- 5 -
Advertisement
Table of Contents
