Mounting Of Table Top With Clutch Motor - Global ZZ 1560 Series Instruction Manual & Instruction For Service Manual

3.2 Stand table assembly
3.2.1

Mounting of table top with clutch motor

7 6 4 3 5 7 1 2
–
Turn the table top (1) upper side down.
–
Screw the drawer (2) on.
–
Set the oil tray (3) so that the oil tray inside aligns with the recess
in the table top and screw it on.
–
Screw the clutch motor(4) on.
–
Screw the lighting transformer (5) on - attachment.
–
Screw the switch (6) on.
–
Mount electric cables according to section 5 of these Instructions
and fix them to the stand table top with clamps.
–
Screw the stand frame to the table top - pre-drilled holes (7).
Then turn the stand to the normal position.
–
Mount the yarn stand (8) according to the picture, insert it into the
hole in the table top and fix it with a nut with washer.
–
Fix the machine head support (9).
–
Stick rubber hinge bottoms (10) and rubber corners (11) with a
suitable contact glue. Stick horizontal fitting surfaces of the hinge
bottoms only. You can also fix the hinge bottoms by means of wood
screws which must be then screwed down so deep so that there is
no contact of the wood screws and the machine head.
8
11
9
10
GB
5