Accessories; Easyfix Video Conferencing Unit; Easyfix Proximity Sensor - Legamaster ETX Series User Manual

13. ACCESSORIES

13.1. EASYFIX VIDEO
CONFERENCING UNIT
Instantly turns the ETX e-Screen into a full video
conferencing screen.
13.1.1 Specifications
• Camera resolution: 1920x1080 / 1280x720
@ 30 hz
• Pixels: 2 million
• Angle (diagonal): 85®
• 4 microphone array, Voice pick-up distance up
to 8 meters
• Automatic Echo Cancellation
• Power: DC 5V±0.2V, 60 Hz // 370 mA
• Supported operating systems: Windows /
Android
13.1.2 Installation
• Use the 2 screws and fix the unit to the top
bezel of the ETX-XX20 (PLUS) e-Screen
• Plug the USB cable into the upper USB-slot (No.
20)
• Plug the audio-cable into the upper audio-in
port (No. 21)
13.1.3 Operation
• The unit is plug-and-play, open any application
on either Android, OPS or any attached PC.

13.2. EASYFIX PROXIMITY SENSOR

Allow the ETX e-Screen to switch between sleep and
wake based on room presence
13.2.1 Specifications
• Detection method: Infrared
• Detection angle: 100®
• Detection range: 5-7 m
• DC 5V±0.5V
• Connection: USB-A
13.2.2 Installation
• Plug the unit into the USB-A port located on the
lower bezelf of the screen, or (ETX-5520 only) on
the left side of the screen.
• Fix the unit onto the screen using the 2 screws
supplied
13.1.3 Operation
The unit is plug-and-play. The unit is controlled by the
below settings, found in the settings menu of the ETX-
XX20 e-Screen. Navigate to the settings-menu. In the
'system' part of the settings menu, press power:
• Enable the 'motion wake-up' setting to allow the
proximity sensor to switch the ETX e-Screen from
sleep to working mode
• Use the 'motion detection' setting to allow the
ETX e-Screen to switch itself to sleep mode when
no presence is detected in the field of view of the
proximity sensor for a certain amount of time.
ETX-SERIES – USER MANUAL – ENGLISH
APPENDIX
29