Float Menu; Settings Menu - Legamaster ETX Series User Manual

5.3. FLOAT MENU

A float menu appears when you swipe up from the
bottom edge of the screen.

5.4. SETTINGS MENU

Below you can find a full overview of the settings menu of the ETX-XX20 e-Screen, together with an explanation
of the settings.
MAIN SETTINGS SETTING
CATEGORY CATEGORY
Ethernet
NETWORK &
Wi-Fi
CONNECTED
DEVICES
Portable
hotspot
Bluetooth
DEVICE Picture
LEVEL1 LEVEL2
MAC address
IP address
Ethernet
MAC address
IP address
Wi-Fi
Hotspot
Setup Wi-Fi hotspot
MAC address
Blooth
Picture mode
Power mode
Color tempreture
Eye protect
Anti blue light
Backlight
OPERATING THE SCREEN
In this float-menu, 3 Action-buttons can be
found with the following functionality:
Back: takes you back to the previous
screen
Home: brings you back to the home screen
of the Legamaster Launcher
Overview: Shows all open apps and allows
users to quickly switch between them, or
close all open apps at once.
VALUES
shows the MAC address for the wired connection
shows the IP address for the wired connection
Toggle ethernet-connection on / off for the screen itself.
ON/OFF
Disabling this does not disable ethernet for the OPS
shows the MAC address for the Wi-Fi connection
shows the IP address for the Wi-Fi connection
ON/OFF Toggle Wi-Fi on and off
ON/OFF Toggle the hotspot-functionality on / off
Set-up the hotspot
show the MAC address for the bluetooth adapter
Toggle bluetooth on/ off, show / connect with available
ON/OFF
devices
Standard
Dynamic Select pre-set picture modes
Soft
Picture mode where settings can be adjusted manually in
User
‚Advanced'
User
Choose a power-mode: User = manual brightness
Auto
setting, Auto = Automatic brightness setting based on
Balanced ambient light conditions, balanced = brightness 75, ECO
= brightness 50, DCR = 100. Power consumption varies
ECO Friendly
based on these settings.
DCR
Standard
Cool Select a color temperature mode
Warm
Toggle Eye Protect mode on / off. When enabled, the
ON/OFF
brightness will be reduced when writing.
Toggle Anti blue light on / off. When enabled the amount
ON/OFF
of blue light will be reduced.
Manually adjust the brightness. Using this setting will
0-100
change the power mode setting to ‚Manual'
EXPLANATION
ETX-SERIES – USER MANUAL – ENGLISH
15