Table of Contents
Advertisement
Installation & Mounting Instruction
These units are to be surface mounted and may be subject to Australian Building
Code Regulations or architectural drawings for height location and fitment, for able
bodied and/or disabled use as may be applicable, which is the responsibility of the
installation contractor to ensure compliance re fitment.
1. Determine appropriate height/location and level on wall, and using template
provided, locate fixing holes, mark and drill wall, fit anchors as supplied if
applicable. Suitable height for hole "D" is 130cm from ground.
2. Fasten unit to wall using anchors provided, or alternate fasteners into noggins if
applicable with appropriate hardware. Once fitted off and *powered, test unit for
effective operation
3. * Electrical connection must be only undertaken by a suitably qualified electrical
contractor.
Wiring Diagram
A. Connect the live wire (colored red or brown) tothe terminal block marked "L".
B. Connect the neutral wire (colored black or blue) to the terminal block marked "N".
C. Connect the ground wire (colored green & yellow) to the green screw marked " ".
Page | 7
Advertisement
Table of Contents
