Advertisement
SX5A AS-Interface
Specifi cations
Models
PWR
AUX
LED Indicators
OUT
FAULT
Address
Addressing Method
Assignment
Certifi cation
Standards
258
SX5A-SWN40S02
IN
Remove the protection cap from the addressing port on the I/O module. Connect the hand-held programming device (SX9Z-
ADR1N) to the addressing port on the I/O module using the programming device cable (SX9Z-CN1), then the I/O module
stops communication through the AS-Interface line. Change slave addresses using the programming device.
SX5A-SWN40K02N
AS-Interface power: Green LED
—
4 yellow LEDs
—
Error indication: Red LED
ON: Communication error or address 0
Flash: Sensor power supply or output is overloaded
AS-International Association
UL/c-UL, CE
www.idec.com
Communication & Networking
SX5A-SWM22KS2N
SX5A-SWM43KS2N
External auxiliary power U (
): Green LED
AUX
2 yellow LEDs
4 yellow LEDs
2 yellow LEDs
3 yellow LEDs
Advertisement
