Advertisement
Communication & Networking
Address Assignment for Communication Terminals
Remove the protection cap from the addressing port on the I/O module.
Connect the hand-held programming device (SX9Z-ADR1N) to the addressing
port on the I/O module using the programming device cable (SX9Z-CN1), then the
I/O module stops communication through the AS-Interface line. Change slave
addresses using the programming device.
For addressing procedures, see the user's manual for the hand-held programming
device.
Hand-held programming
device SX9Z-ADR1N
Programming device cable
SX9Z-CN1
Addressing port
SX5A I/O Terminal (IP67)
• SX5A-SWN40S02
• SX5A-SWN40K02N
• SX5A-SWM22KS2N
• SX5A-SWM43KS2N
Using SwitchNet Addressing Port Adapter on HW
To open the addressing port lid, insert a screwdriver into the side slot as shown.
Do not lose the lid.
Addressing
port lid
Attach the addressing port adapter to the programming device cable and insert
the addressing port adapter into the addressing port on the communication block.
Addressing port
SX5A I/O Terminal (IP20)
• SX5A-SSN40S0N
• SX5A-SSN40K0N
• SX5A-SSM43KSN
SwitchNet addressing
port adapter LA9Z-SNADP
Hand-held programming device
USA: 800-262-IDEC
SX5A AS-Interface
Address Assignment for SwitchNet
Turn off the power to the SwitchNet control unit and open the lid of the address-
ing port. Connect the programming device cable (SX9Z-CN1) to the hand-held
programming device (SX9Z-ADR1N) and attach the SwitchNet addressing port
adapter (LA9Z-SNADP) to the programming device cable (SX9Z-CN1). Insert the
addressing port adapter into the addressing port on the SwitchNet control unit.
Change slave address using the programming device.
For addressing procedures, see the user's manual for the hand-held programming
device. After completing address assignment, reattach the lid to the addressing
port.
Hand-held programming
device SX9Z-ADR1N
Programming device
cable SX9Z-CN1
SwitchNet HW
communication block
Using SwitchNet Addressing Port Adapter on L6
To open the addressing port lid, insert a screwdriver into the right-side hole as
shown. The addressing port lid can be removed from the communication block by
pulling it out.
Addressing
port lid
Attach the addressing port adapter to the programming device cable and insert
the addressing port adapter into the addressing port on the communication block.
Canada: 888-317-IDEC
SwitchNet addressing
port adapter LA9Z-SNADP
SwitchNet L6
communication block
SwitchNet addressing
port adapter LA9Z-SNADP
265
Advertisement
