WARRIOR 68115 Owner's Manual & Safety Instructions

18 piece carbon steel hole saw set

Owner's Manual & Safety Instructions

Save This Manual

operating, inspection, maintenance and cleaning procedures. Write the product's serial number in the

back of the manual near the assembly diagram (or month and year of purchase if product has no number).

Keep this manual and the receipt in a safe and dry place for future reference.

Visit our website at: http://www.harborfreight.com

Email our technical support at: productsupport@harborfreight.com

When unpacking, make sure that the product is intact

and undamaged. If any parts are missing or broken,

please call 1-888-866-5797 as soon as possible.

2011 by Harbor Freight Tools

No portion of this manual or any artwork contained herein may be reproduced in

any shape or form without the express written consent of Harbor Freight Tools.

Diagrams within this manual may not be drawn proportionally. Due to continuing

improvements, actual product may differ slightly from the product described herein.

Tools required for assembly and service may not be included.

Keep this manual for the safety warnings and precautions, assembly,

Read this material before using this product.

Failure to do so can result in serious injury.

SAVE THIS MANUAL.

20e

Table of Contents

Need help?

Do you have a question about the 68115 and is the answer not in the manual?

Page 1 Owner’s Manual & Safety Instructions Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference.
Page 2 Inspect before every use; do not be supplied by the operator. use if parts are loose or damaged. SAVE THESE INSTRUCTIONS. Page 2 For technical questions, please call 1-888-866-5797. Item 68115...
Page 3 Drive Plate may have been used. Open Jaws of Drill Chuck (sold separately). Place the Mandrel Shaft completely into the Chuck and securely tighten the Chuck. Drive Plate (some saws) Mandrel Item 68115 For technical questions, please call 1-888-866-5797. Page 3...
Page 4 OPERATION Holding the drill at 90° to the workpiece, When finished, remove set the Hole Saw on the workpiece. the Hole Saw from drill’s chuck. Press the drill’s trigger to turn it on. Remove Hole Saw from the Mandrel and clean off Hole Saw with a cloth. If the drill is a variable speed type, cut the workpiece slowly until a circle Store the Hole Saws inside case,...