I. INTRODUCTION This kids bike helmet is made of the lightest and safest materials, which makes it more comfortable and safer. Its fine ventilating structure inside Children main control enables air to flow smoothly through so as to achieve the Charging port best cooling effect.
Page 3
Front Back the buckle. Flatten the drawstrings on both side and make them clinging to your face, buckle up it when the helmet is tightly put on. If the drawstrings become loose, please take off the helmet and adjust it properly. When adjusting the drawstrings, please use one hand to fix the buckle and then adjust the drawstrings within proper tightness.
Page 4
the front of the helmet, loose the drawstring and tighten the rear drawstring. Comfort Adjustment In order to check the tightness of the helmet, you can put on the helmet and buckle it up, and open your mouth to feel whether the drawstrings are closely attached to your chin, and then move your helmet forward and backward.
Page 5
IV. OPERATING INSTRUCTION Start up (Please charge the battery before use.) When the device is powered off, knock it three times within 1.5s. It starts up with the front and tail lights on. Shut down When the device is in the working state, knock it three times within 1.5s. It shuts off with the front and tail lights off.
Page 6
V. PRECAUTIONS Temperature LIVALL kids bike helmet consists of intelligent electronic system, plastics, EPS foam, etc. And the intelligent electronic system contains polymer battery. Therefore, like other consuming electronic products, it requires certain environmental temperature and has some limit in temperature changes.
Page 7
Safety Precautions This helmet is designed to burden damages and injuries from external impact. Although such injury may seem minor, it could damage the helmet. If the helmet is damaged from falling or other causes, please discard the helmet and replace it with a new one. Some accidents are unavoidable for whatever kids bike helmet and the damaging degree may differ from the impacting;...
Page 8
The helmet is designed to absorb shock by destroying the rubber shell and inner pad. Destruction of this kind cannot be seen from the appearance of the helmet. So you should change a new one when your helmet suffers a heavily shock even if it looks damage-free. The helmet will be damaged and functionless when exposed in gas or products like detergent, paint, agglutinant that contain gas, even if it looks damage-free.
0 ℃ ~40 ℃ (32 ℉ ~104 ℉ ) Notified Body: ITS Testing Services (UK) Ltd., Centre Court, Meridian Business Park, Leicester LE19 1WD No. 0362 Original design manufacturer: Shenzhen Qianhai LIVALL IoT Technology Co., Ltd. Address: 904, R&D Building Tsinghua Hi-Tech Park, NanShan, Shenzhen, China Postal code:...
Page 10
After-Sales Information: product. 3. The warranty card is a guarantee for free maintenance Thank you for purchasing LIVALL product, please read within a specified time period and under stipulated the following instructions for better service: conditions. Please keep it well and, in case after-sale 1.
Page 11
WARNING This helmet is intended for use for biking, skateboarding, inline skating. Not for motor vehicle use. The helmet is intended to reduce the risk of injuries to the head when an accident happens but it cannot protect against every kind of injuries. Do not make any changes to the helmet that might impair its protective capacity.
Page 12
INSTRUCTIONS FOR USE AND CARE A. No Helmet can protect the wearer against all possible impacts. B. The Helmet is designed to be restrained by a strap under the lower jaw. C. To be effective, a Helmet must fit and be worn correctly. To check for correct fit, place helmet on head and make any adjustments indicated.