Page 2
.Introduction Welcome to the User Guide for LIVALL smart helmets. This Guide will help you better use this product. With continuous improvements of our products, this Guide will be updated from time to time. You can access the latest version and learn more about the helmet on www.livall.com.
Page 3
III. Wearing Instructions Incorrect Incorrect Correct Adjust the length of Leave a gap as thick Correctly position Check whether the the chinstrap as one finger the helmet buckle is properly fastened...
Page 4
IV. Operation Instructions Turn On Your Helmet For the first time to use, press the power on button located at the back of the helmet, once the tail lights illuminate the smart helmet is on. Hold the button Note: If it cannot be activated successfully, please charge it and try again.
Page 5
2) Replacing device (When the original BR80 lost or damaged) Put the power-on BR80 close to Press the power button of the Then the tail light of the helmet the main control of the helmet, helmet within 10s to confirm the will continue to flash in the light and the warning light flashes connection of the BR80.
Page 6
1) Download the LIVALL 2) Turn on the Bluetooth on your 3) Click "Device" in the LIVALL Riding app, R i d i n g A p p o n y o u r phone and turn on the helmet;...
Page 7
SOS Alert(need to be connected to LIVALL Riding APP) The helmet has a fall detection sensor which sends a signal to the LIVALL Riding APP via Bluetooth technology when a fall is detected. Then the APP will send an SOS message to a pre-arranged emergency contact.
Page 8
4. If the electronic functions do not work, please charge the helmet for 3 hours and then check if it works normally. The helmet contains impact detection devices. Only if you connect your helmet with LIVALL Riding App and start ride mode on the App, when your helmet suffers from the heavy impact, SOS alert feature can be triggered.
Page 9
Temperature: Storage Temperature: -20°C ~45°C. Temperature for use: 0°C~40°C. Temperature while charging: 0°C~40°C. Notes: The above data is measured by LIVALL in a controlled environment, with room temperature at 25°C and specific light patterns. The actual data might be different according to the environment.
Page 10
During the usage, if the following troubles occur, please charge the product according to quick guide of the model(the helmet can be reset during the charging). If the problems still can not be solved, please contact the after- sales service center. (After-sales email: riding@livall.com) Faults: 1.
Page 11
This helmet is in conformity with the regulation (EU) 2016/425; This helmet is in conformity with the Personal Protective Equipment (Enforcement) Regulations 2018; LIVALL Tech Co., Ltd. declare that the full EU Declaration of conformity and UK Declaration of conformity are available on the Internet at http://www.livall.com/tech/product.html...
Page 12
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Page 24
Notified Body: Telefication B.V. with its office located at Wilmersdorf 50, 7327 AC Apeldoorn, The Netherlands. Notified Body No. 0560 Original Design Manufacturer: LIVALL Tech Co., Ltd. Address: 904, R&D Building Tsinghua Hi-Tech Park, NanShan, Shenzhen, China Postal Code: 518057 Website: www.livall.com...