Subscribe to Our Youtube Channel
Related Manuals for SIIG Security Countertop Kiosk & POS Stand for iPad
Summary of Contents for SIIG Security Countertop Kiosk & POS Stand for iPad
- Page 1 Security Countertop Kiosk & POS Stand for iPad Installation Instructions 04-1047C...
-
Page 2: Safety Information
Unpacking • Carefully remove the contents and lay them out on cardboard or other protective surface • Check package contents against the parts list to ensure that all components were received and undamaged. Do not use damaged or defective parts •... -
Page 3: Installation
Installation Step 1 - Mount the Rubber Pads to the Weighted Base Turn the weight base so that the countersinked holes are facing up. Remove the adhesive protection from the Rubber Pads (D). Mount the Rubber Pads (D) onto the weighted base, see Figure 1. Figure 1 Step 2 - Mount the Support Pole to the Weighted Base Install the Decorative Cover (E) and Support Pole (B) to the Weighted Base (C), secure them using M8x20 Bolt (J), tighten each bolt with Allen Key (L) by turning it clockwise until fully tight, see Figure 2. - Page 4 Step 3 - Mounting to the Countertop 3A) Weighted Base Installation Simply place the stand directly onto the countertop. The weighted base will secure the stand, see Figure 3A. Figure 3A 3B) Permanent Wood Countertop Installation Place the stand in the desired position. Lift up the decorative cover and mark the left and right positions of the mounting holes, see Figure 3B.
- Page 5 3C) Permanent Concrete/Brick Countertop Installation Place the stand in the desired position. Lift up the decorative cover and mark the left and right positions of the mounting holes, see Figure 3C. Remove the stand. Drill holes using an electric drill and a 3/8" masonry drill bit to a depth of approximately 2.4" into the concrete/brick countertop at each marked location.
- Page 6 Step 4 - Mounting the iPad Holder If the cover is locked to the holder, insert Key (H) into the security lock and turn it counterclockwise to unlock, then remove the cover, see Figure 4A. Place the holder so that the security lock is on the top. Secure the holder to the support pole using M5x6 Bolt (I), see Figure 4B.
- Page 7 Step 5 - Arranging the iPad Mount 5A) For iPad 2 / 3 / 4 The Silicon Posts come pre-configured to fit iPad 2 / 3 / 4 models. No adjustment is needed for use with these iPad models. Replace the currently mounted 7mm Foam Pads with the included 5mm Foam Pads, see Figure 5A.
- Page 8 Step 6 - Installing iPad Place your iPad into the holder so that it rests on the foam pads and is supported by the Silicon Posts. Connect the iPad's charging cable and route the cable through the cable management slot, see Figure 6. Figure 6 Step 7 - Installing the Cover onto the iPad Holder Insert the Key (H) into the lock, turn it counterclockwise to unlock, see Figure 7.
- Page 9 Step 8 - Final Adjustments Tilt Angle Adjustment Adjust the tightness of tilt angle using 4mm Allen Key (K), see Figure 9. Figure 9 Rotation Adjustment (Optional) Remove the iPad from the holder. Using a Phillips screwdriver, turn the screws clockwise to tighten and counterclockwise to loosen, see Figure 10. Rotation Adjustment Screw Rotation Adjustment Screw Rotation Adjustment Screw Figure 10...
-
Page 10: Maintenance
Disable the Home Button Remove the iPad Holder's cover. Remove the Silicone button from the cover. Insert the the Plastic Button (M) into the opening, see Figure 11. Reinstall the cover and lock it in place. Figure 11 Viewing Angle Adjustment This stand allows tilt viewing angle of 0 to -75 degrees and rotation viewing angle of 0 to 90 degrees, see Figure 12. Figure 12 Maintenance Check the mounting hardware every two months for tightness. - Page 11 Blank Page...
-
Page 12: Technical Support And Warranty
Security Countertop Kiosk & POS Stand for iPad Security Countertop Kiosk & POS Stand for iPad is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. All other names used in this publication are for identification only and may be trademarks of their respective owners.
Need help?
Do you have a question about the Security Countertop Kiosk & POS Stand for iPad and is the answer not in the manual?
Questions and answers