TAKIMA tools TKJS-85 Manual page 8

blade recommendations are to be observed.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
2 Thumbwheel for stroke rate preselection
3 On/Off switch
4 Lock-on button for On/Off switch
5 Allen key
6 Switch for sawdust blowing device
7 Adjusting lever for orbital action
8 Base plate
9 Guide roller
10 Saw blade*
11 Contact protector
12 Handle (insulated gripping surface)
13 Stroke rod
14 Splinter guard*
15 Scale for mitre angle
16 Screw
17 Positioning pin/mark
18 Bolt hole
19 Lead for the parallel guide
20 Locking screw for parallel guide*
21 Parallel guide with circle cutter*
22 Centring tip of the circle cutter*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our accessories
program.
ESPECIFICACIONES
Modelo
Voltaje
Frecuencia
Entrada Potencia
Velocidad
Capacidad máxima de corte
en Acero
en Madera
Assembly
• Before any work on the machine itself, pull
the mains plug.
Replacing/Inserting the Saw Blade
• When mounting the saw blade, wear
protective gloves.
Danger of injury when touching the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades
can be found at the end of these instructions.
Use only T-shank saw blades. The saw blade
should not be longer than required for the
intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting/Replacing the Saw Blade (see
figure A)
Before inserting the saw blade 10, set the
adjusting lever for orbital action 7 to setting III.
Insert the saw blade 10 lateral to the cutting
direction into the stroke rod 13.
Turn the saw blade 10 so that the toothing
faces toward the cutting direction. Pull the saw
blade 10 a little downward until it engages.
While inserting the saw blade, pay attention
that the back of the saw blade is positioned in
the groove of the guide roller 9.
• Check the tight seating of the saw blade.
7
TKJS-85
110V
60Hz
580W
500-3000R/Min
10mm
85mm