Advertisement
Available languages
Available languages
Clean the saw blade holder regularly. For this,
remove the saw blade from the machine and
lightly tap out the machine on a level surface.
Heavy contamination of the machine can
lead to malfunctions. Therefore, do not saw
materials that produce a lot of dust from below
or overhead.
• In extreme conditions, always use dust
extraction as far as possible. Blow out
ventilation slots frequently and install a
residual current device (RCD). When working
metals, conductive dust can settle in the
interior of the power tool. The total insulation of
the power tool can be impaired.
Lubricate the guide roller 9 occasionally with a
drop of oil.
Check the guide roller 9 regularly. If worn,
it must be replaced through an authorised
TAKIMA after-sales service agent.
If the replacement of the supply cord is
necessary, this has to be done by TAKIMA or
an authorized TAKIMA service agent in order
to avoid a safety hazard.
If the machine should fail despite the care
taken in manufacturing and testing procedures,
repair should be carried out by an after-sales
service centre for TAKIMA power tools.
Advertisement
