Advertisement
Available languages
Available languages
Remove the saw blade from the machine and
allow the machine to cool down by running it
for approx. 3 minutes at maximum stroke rate.
Working Advice
• Before any work on the machine itself, pull
the mains plug.
• When working small or thin work pieces,
always use a sturdy support or a saw table
(accessory).
Check wood, press boards, building materials,
etc. for foreign objects such as nails, screws or
similar, and remove them, if required.
While working, hold the machine by the handle
12 and guide it alongside the desired cutting
line. For precise cuts and quiet running, guide
the machine additionally with the other hand.
Contact Protector
The contact protector 11 attached to the casing
prevents accidental touching of the saw blade
during the working procedure and may not be
removed.
Plunge Cutting (see figure E)
• The plunge cutting procedure is only
suitable for treating soft materials such as
wood, plaster board or similar! Do not work
metal materials with the plunge cutting
procedure!
Use only short saw blades for plunge cutting.
Plunge cutting is possible only with the mitre
angle set at 0°.
Place the machine with the front edge of the
base plate 8 on to the workpiece without the
saw blade 10 touching the workpiece and
switch on. For machines with stroke rate
control, select the maximum stroke rate. Firmly
hold the machine against the workpiece and
by tilting the machine, slowly plunge the saw
blade into the workpiece.
When the base plate 8 fully lays on the
workpiece, continue sawing along the desired
cutting line.
P a r a l l e l G u i d e w i t h C i r c l e C u t t e r
(Accessory)
For cuts using the parallel guide with circle
cutter 21 (accessory), the thickness of the
material must not exceed a maximum of 30
mm.
Parallel Cuts (see figure F): Loosen the locking
screw 20 and slide the scale of the parallel
guide through the lead 19 in the base plate.
Set the desired cutting width as the scale value
on the inside edge of the base plate. Tighten
the locking screw 20.
Circular Cuts (see figure G): Set the locking
screw 20 to the other side of the parallel guide.
Slide the scale of the parallel guide through
the lead 19 in the base plate. Drill a hole in the
workpiece centred in the section to be sawn.
Insert the centring tip 22 through the inside
opening of the parallel guide and into the
drilled hole. Set the radius as the scale value
on the inside edge of the base plate. Tighten
the locking screw 20.
Coolant/Lubricant
When sawing metal, coolant/lubricant should
be applied alongside cutting line because of
the material heating up.
Maintenance and Service
Maintenance and Cleaning
• Before any work on the machine itself, pull
the mains plug.
• For safe and proper working, always keep
the machine and ventilation slots clean.
10
Advertisement
