Advertisement
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
1: Maintained (*)
A: Including test device
B: Including remote test mode
C: Including inhibiting mode
F: Automatic test gear complying
with IEC 61347-2-7 denoted EL-T
G: Internally illuminated
60: 1 hour duration
180: 3 hours duration
480: 8 hours duration
(*) Maintained operation: The luminaire lights its illumination source, when it is powered by
the mains power supply or not.
Non Maintained operation: The luminaire lights its illumination source, only in power supply's
failure.
Battery replacement.
It can be done only by a competent person and after the mains supply interruption.
1. Dismantle the device (step 1 and step 2 of the installation instructions).
2. Disconnect the connector and remove the old battery.
3. Connect the new battery with the same type (step 6 of the installation instructions) and
place it in the position of the old one.
4. Follow the step 7 of the installation procedure and power the device.
Manufacturer
Model Number
Voltage Range
Nominal Power
Connections
Temperature (tc)
The light source contained in this luminaire shall only be replaced by the manufacturer, or his
agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of warranty
is specified in the official catalogue of Olympia Electronics and also in the technical leaflet, which
accompanies each product. This warranty ceases to exist if the buyer does not follow the technical
instructions included in official documents given by Olympia Electronics or if the buyer modifies the goods
provided or has any repairs or re-setting done by a third party, unless Olympia Electronics has fully
agreed to them in writing. Products that have been damaged can be returned to the premises of our
company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge the
buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or not the
buyer the transportation cost.
HEAD OFFICE
72
km. O.N.R. Thessaloniki-Katerini
nd
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
info@olympia-electronics.gr
Page 5 from 5
NOTE!! The installer should fill in, on the specification
label, the letter G if the luminaire is used as a safety sign.
LED MODULE CHARACTERISTICS
GR-750/ST/HP/LL/WL GR-751/ST/LP/LL/WL GR-752/ST/HP/HL/WL GR-753/ST/LP/HL/WL
13-13.6VDC
1.5W max
Non-reversible connection between main pcb and led module
45 °C max. across the board
X 1
A B C F
G
Olympia Electronics S.A
2505195
1 8 0
13-14VDC
2W max
923753004_09_001
Advertisement
