Download Print this page

olympia electronics BAU LIGHT Series Manual page 3

Self testing maintained emergency luminaires

Advertisement

Wireless Communication LED indications
The top LED (LD3-green)
network connection status.
This LED may blink according to the following
patterns:
1. Steady ON: The device has established
direct connection to a Gateway device, and at
least one more Gateway device is available for
alternate routing
(false condition).
2. Rapid flash [5 times/s]: The device has
established direct connection to a single
Gateway device.
3. Fast flash [2 times/s]: The device has
established connection to a Router device and
at least one
available on the same hop level, as an alternate
route (redundant connection).
4. Moderate flash [1 second ON / 1 second
OFF]: The device has established connection to
a single Router device, and no alternatives
exist on the same hop level.
5. No light: The device is disconnected.
The middle LED (LD2-green) indicates the
received signal strength (RSSI) of the router
module.
This LED may blink according to the following
patterns:
1. Very fast flash [5 times/s]: received signal
strength is excellent.
2. Fast flash [2 times/s]: received signal
strength is good.
3. Moderate flash [1 second ON / 1 second
OFF]: received signal strength is acceptable for
reliable communication.
4. Very slow [2 seconds ON / 2 seconds OFF]:
received signal strength is not acceptable for
reliable communication, or no signal.
The bottom LED (LD1-red) indicates operation
status.
This LED may blink according to the following
patterns:
1. Very fast blink [5 times/s]: the module is not
initialized correctly. In this case you have to
press for
push button, in order to reset the module (loads
default settings).
2. Moderate flash [2 times/s]: The module is
properly operating.
Button functionality:
The on-board button has the two following
functions:
1. Short press (<2"): a status message will be
sent to the Gateway device of the wireless
Page 3 from 5
indicates the
more Router device is
more than 2 seconds the
network.
2. Long press (>2"): Loads factory default
settings to the module.
Default settings:
• SID: 00000001
• RF Channel: 13 ( 869.525MHz )
Button
Antenna
LD3
LD2
LD1
923753004_09_001

Advertisement

loading

This manual is also suitable for:

Bau light gr-750/st/hp/ll/wlBau light gr-751/st/lp/ll/wlBau light gr-752/st/hp/hl/wlBau light gr-753/st/lp/hl/wlGr-750/st/hp/ll/adrGr-751/st/lp/ll/adr ... Show all