PCB Piezotronics 441A35 Installation And Operating Manual page 44

Low Frequency
Response
Low Pass
Filter
Integration
Units
Reference
Overvoltage
Fault
(only sent in
ICP mode)
Zero Lock
(only sent in
long TC charge
mode)
Example:
Manual 19854 Rev. D
ECN 50523
using English units in integration mode.
XX.XX pC/m/s^2 Transducer sensitivity for a charge sensor
using SI units in integration mode.
0.2 Hz Low frequency response 0.2 Hz.
2.0 Hz Low frequency response 2.0 Hz.
Med TC Medium time constant .
Long TC Long time constant.
S Int 1 Hz Single integration to 1 Hz
S Int 10 Hz Single integration to 10 Hz
D Int 1 Hz Double integration to 1 Hz
D Int 10 Hz Double integration to 10 Hz
0.1 kHz Low pass filter set to 100 Hz.
1.0 kHz Low pass filter set to 1.0 kHz.
3.0 kHz Low pass filter set to 3.0 kHz.
10 kHz Low pass filter set to 10 kHz.
30 kHz Low pass filter set to 30 kHz.
100 kHz Low pass filter set to 100 kHz.
SI SI units will be used for input and output
Eng English units will be used for input and output sensitivities in
integration mode.
Ref On The internal sinusoidal reference is on.
Ref Off The internal sinusoidal reference is off.
OV=1 The 443B is overloaded.
OV=0 The 443B is not overloaded.
Fault=1 There is an open or short at the input.
Fault=0 The sensor bias is within the acceptable range.
Zero Lock On The reset is clamped on.
Nothing is sent if zero lock is off.
Command String: "02C02STAT"
Response String: "ICP 2mA;10.00 mV/unit;
1.023 mV/unit;2.0 Hz;10kHz; SI;
443B101/443B102 29