Digistar GT560 AUTOLOG Operator's Manual page 68

D.A.N 6302 Settings:
Determines if the preset is loaded when unloading begins, default is
OFF. Every unloading cycle will use the loaded preset.
OFF – No preset active.
•
STORED – Enter an amount for the maximum truck capacity
•
o Used every time no matter if different trucks with different
TRUCK – Enter an amount for each truck
•
o Used to enter a different preset amount depending on
PARTCP – Enter any amount
•
o Used if a less than full load is required.
To keep the 12VDC output signal deactivated during the unloading
process when any D.A.N. 6302 setting is ON, press
starting PTO.
68
capacities are used.
each trucks capacity.
GT560 Operators Manual
Preset Active Signal Functionality
before
D4168-EN