Digistar GT560 AUTOLOG Operator's Manual page 38

Example Application 1: Grain cart with GT560 AutoLog
activate an external alarm or light to notify truck driver that cart is
unloading. Truck is allowed to hold 40,000 pounds. Grain cart operator
opens and closes doors, and wants to make sure an additional 30
seconds are allowed for cleanout before truck drives away.
(Preset Active (PRA) has to be enabled, Service/Options Setting:
90019). Set 6302 ALP to ON, press
PRESET, press
to store. Using key pad enter 40000, then press
preset weight value. To install, Connect green DC Output wire to
external alarm or light +12V, black to - /Ground.
Operation: Start PTO, GT560 automatically loads 40,000 pound
preset, external alarm light flashes for truck driver. Open door to unload
grain, then close door when near 40,000 pounds. Target weight is
reached; 30 second delay time begins to give cart operator time to
clean out the auger and turn off the PTO. After 30 seconds, external
alarm light turns off, data is logged, and the truck drives away.
Example Application 2: Grain cart with GT560 AutoLog
activate an alarm in tractor cab for 10 seconds to notify operator once
35,000 pounds is unloaded, so that the door can be closed. The
operator has a history of overloading the truck by 5000 pounds each
time.
Set 6302 ALP to ON. Set 4005 RELAY to PRNOPA. Set 6303 PAST to
10.0. Set 6003 to WEIGHT; TOLER to 5000. Press 35000 then
store preset weight. Connect green DC Output wire to alarm +12VDC,
black to ground.
Operation:
Start PTO, GT560 automatically loads 35,000 pound preset.
•
Open door to unload grain. Target weight is reached 5000 pounds
•
early, sounding alarm for operator to close the door. The preset is
deactivated at 30,000 pounds to correct for overfill, and the data is
logged when the PTO is stopped.
38
to store. Set 6303 PAST to 30.0 (seconds), press
GT560 Operators Manual
to store. Set 4005 RELAY to
AutoLog
2
system is to
2
to store
system is to
2
to
D4168-EN