Table of Contents
Advertisement
❻
3) After the completion of editing, click "Current layer setting" ❻ . → ❼ Put a checkmark to the "Sew-
ing pattern" and "Bending point of line". → ❽ Set the stitch pitch (Enter the value obtained by "3
cm ÷ Number of stitches" or 1 "inch ÷ Number of stitches" in the input field of "3.000"). → ❾ Set
the number of reverse feed stitches and the number of times of reverse feed stitching. → If it is
necessary to reduce the sewing speed at the corner of the sewing pattern, put a checkmark to "Use
the speed reduction at bending points" and change the angle of the bending point and the number
of stitches". → Click to confirm.
2) After the completion of setting, click the first
line of stitches you want to sew, and change
the number "8" to "1" (if the number of the first
stitch line is not "1") and confirm.
While keeping the Ctrl key, located at the low-
er left of the keyboard, held pressed (do not
release the key), click the stitch line numbers
with the left button according to the order of
stitching you want to sew.
❼
❽
❾
– 21 –
Advertisement
Table of Contents
