Table of Contents
Advertisement
Operation in Remote mode:
8. Plug the electrical cable cord in the TigerO socket and then connect
it to the electricity mains through a Remote control Timer.
The Input voltage should be: 230V; 50Hz.
9. Turn the Key-Switch to its Remote position (right side).
10. Turn the Main Switch ON.
The White Light will turn ON and the Red light (Standby) will turn ON.
The air-blower will start running and air will be emitted from the outlet
mesh on the upper back side.
11. Leave the room and close the door behind you.
12. Set the ON and Off times on the External (Remote) Timer as needed.
When the External Timer is activated, the Orange light will turn ON
indicating that ozone is being generated and the Red light will turn OFF*.
13. Stopping the operation of the TigerO must be made only by disconnecting
the electricity from the Remote control timer!
----------------------------
(*) Note: If the Orange light is not turned ON and the Red light is still
staying ON (Error) this is an indication of a failure: See Trouble shouting.
Do not attempt to re-enter the room while it contains ozone.
Important: After the treatment is completed and only after the residual ozone has
been decomposed down below the safety level, you may re-enter the treated room.
Note that the time for ozone decomposition may take several hours depends on the
room volume and on the ozone generation time.
Before re-entering the room, please open all windows and doors for refreshing
the air in the treated room.
Ozone is a powerful oxidant and hazardous gas!
Avoid any exposure of ozone to people, pets and plants!!!
Warning:
CAUTION
9
Advertisement
Table of Contents
