Electrical Information - Nobu GR-10L User Manual

Table of Contents

Advertisement

Available languages

Available languages

SAFETY PRECAUTIONS
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar cover-
ings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and
where it will not be tripped over.
• Do not open the unit during operation.
• When the air filter is to be removed, do not touch the metal parts of the unit.
• Hold the plug by the head of the power plug when taking it out.

Electrical Information

• The manufactures nameplate is located on the rear panel of the unit and contains electrical and
other technical data specific to this unit.
• Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding is
important. The power cord is equipped with a three-prong grounding plug for protection against
shock hazards.
• Your unit must be used in a properly grounded wall receptacle. If the wall receptacle you intend
to use is not adequately grounded or protected by a time delay fuse or circuit breaker(the fuse or
circuit breaker needed is determined by the maximum current of the unit. The maximum current is
indicated on the nameplate located on unit), have a qualified electrician install the proper recepta-
cle.
• Ensure the receptacle is accessible after the unit installation.
• Do not use extension cords or an adapter plugs with this unit. However, if it is necessary to use
an extension cord, use an approved Dehumidifier extension cord only (available at most local
hardware stores).
• To avoid the possibility of personal injury, always disconnect the power supply to the unit, before
installing and/or servicing.
• All wiring must be performed strictly in accordance with the wiring diagram located on the middle
baffle of the unit (behind the water bucket).
Take note the fuse specifications
The unit s circuit board (PCB) is designed with a fuse to provide overcurrent protection. The speci-
fications of the fuse are printed on the circuit board, such as: T 3.15A/250V (or 350V), etc.
NOTE: All the pictures in the manual are for explanation purposes only. The actual shape of the
unit you purchased may be slightly different, but the operations and functions are the same.
Note About Fluorinated Gasses
-Fluorinated greenhouse gases are contained in hermetically sealed equipment. For specific infor-
mation on the type, the amount and the CO2 equivalent in tonnes of the fluorinated greenhouse
gas (on some models), please refer to the relevant label on the unit itself.
-Installation, service, maintenance and repair of this unit must be performed by a certified techni-
cian.
-Product uninstallation and recycling must be performed by a certified technician.
8

Advertisement

Table of Contents
loading

Table of Contents