LEGRAND Kenall MILLENIUM METREX METSS Series Installation Instructions

MILLENIUM METREX
METSS SERIES
When using electrical equipment, basic safety precautions should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT TO
AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING

PREPARATION

• Read all fixture markings and labels to
insure correct installation of the fixture.
Additional information may be located on
the fixture or in supplemental instructions
sheets, separate from this instruction sheet,
regarding orientation,mounting restrictions
and optional equipment.location installation,
attach self-adhesive pad GASKET to
MOUNTING PLATE. Using 1/4-20 fasteners
and anchors appropriate for the mounting
surface (not supplied), attach MOUNTING
PLATE to structure. Connect supply ground
to GROUND WIRE provided. For wet location
Installation, attach self-adhesive pad GASKET
to CANOPY COVER. Using HARDWARE
provided, attach CANOPY COVER and
HOUSING to CANOPY MOUNTING PLATE.
• For Peace of Mind Warranty, fixture must be
mounted to building with at least 4 fasteners
(4 point mounting). Attachment to the
electrical box only is NOT recommended.
• WARNING: Disconnect power to the
circuit before wiring fixture.
www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of speci cation sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg. Co.
™
•
•
•
•
•
ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS

IMPORTANT SAFEGUARDS

READ AND FOLLOW ALL SAFETY INSTRUCTIONS
DO NOT USE OUTDOORS.
DO NOT MOUNT NEAR GAS OR ELECTRIC HEATERS.
EQUIPMENT SHOULD BE MOUNTED IN LOCATIONS AND AT HEIGHTS WHERE
IT WILL NOT BE SUBJECTED TO TAMPERING BY UNAUTHORIZED PERSONNEL.
THE USE OF ACCESSORY EQUIPMENT NOT RECOMMENDED BY THE
MANUFACTURER MAY CAUSE AN UNSAFE CONDITION.
DO NOT USE THIS EQUIPMENT FOR OTHER THAN ITS INTENDED USE.
1
F-2935