Makita M5802 Instruction Manual page 7

1
Fig.10
► 1. Switch trigger 2. Lock button / Lock-off button
For tool with lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop. For continuous operation,
pull the switch trigger, push in the lock button and then
release the switch trigger. To stop the tool from the
locked position, pull the trigger fully, then release it.
CAUTION:
Switch can be locked in "ON" posi-
tion for ease of operator comfort during extended
use. Apply caution when locking tool in "ON"
position and maintain firm grasp on tool.
For tool with lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
NEVER defeat the lock-off button
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
WARNING:
NEVER use the tool if it runs when
you simply pull the switch trigger without press-
ing the lock-off button. A switch in need of repair
may result in unintentional operation and serious
personal injury. Return tool to a Makita service center
for proper repairs BEFORE further usage.
NOTICE:
Do not pull the switch trigger hard
without pressing in the lock-off button. This can
cause switch breakage.
ASSEMBLY
2
switched off and unplugged before carrying out
any work on the tool.
Removing or installing circular saw
blade
installed with teeth pointing up at the front of the
tool.
install or remove the circular saw blade.
To remove the circular saw blade, press the shaft lock
fully so that the circular saw blade cannot revolve and
use the wrench to loosen the hex bolt counterclockwise.
Then remove the hex bolt, ring (country specific), outer
flange and circular saw blade.
Fig.11
► 1. Hex wrench 2. Shaft lock 3. Loosen 4. Tighten
For tool without the ring
Fig.12
► 1. Hex bolt 2. Outer flange 3. Circular saw blade
7 ENGLISH
CAUTION:
Always be sure that the tool is
CAUTION:
Be sure the circular saw blade is
CAUTION:
Use only the Makita wrench to
3
4
3
2
1
4. Inner flange
1
2
4