- Cosmic Ampworks
(Wire to tonestack)
Figure 16. Solder a length of some 15 cm of wire to the rear hole of (the removed) R58. For now, ignore the diagonally mounted
resistor and the other two wires (they are part of the - optional - presence control and modified phase inverter, see further
down).
Tonestack IN, from rear hole of
(removed) R58 (Figure 11)
Figure 17. The tonestack (the left two potmeters) and volume control (right pot) assembly has 3 connection points to the circuit
board: SIGNAL IN (from rear hole of the removed R58 - Figure 11), SIGNAL OUT (the left hole of the removed R24 – this Figure) and
GROUND (the leftmost hole of the removed original volume pot VR5.
© 2020 -
www.cosmicampworks.com
- The Ultimate Harley Benton GA15 Mod Kit- Version 1.4 - 200127
®
15
Tonestack OUT, to left
hole of (removed) R24
Dedicated to the Advancement of Stellar Tone!
Ground wire
Ground wire to
circuit board ground