Advertisement
Step 2
Install the back subframe support brackets (which will be located towards the front of the
vehicle) using supplied vehicle factory hardware and 2 fender washers. Do not fully tighten
brackets. (Brackets are symmetric and are not side specific).
Step
3
Fasten, but do not tighten middle brackets to subframe on left and right sides using 10-32 x
1/2" RD Head Bolt, #10 Flat Washer and #10 Nyloc Nut. Ensure bracket is on inside of
subframe flange as seen in the below figures.
Step 4
Place and center subframe into vehicle ensuring the
subframe
aligns with preinstalled rear brackets and ensuring mid mounting brackets align with vehicle
holes. Mid bracket can be adjusted to help alignment of mounting holes. Use front lip spac-
ing to help with proper alignment seen in 3rd & 4th figures below.
LS
RS
3
Advertisement
