Advertisement
Step 8
Using vehicle factory hardware install the subframe front mount brackets on the left and
right side (located at the furthest rear of the vehicle) and do not fully tighten.
Step 8
Assemble middle support bracket using x2 10-32 x 1/2" RD Head Bolt, #10 Flat Washer
and #10 Nyloc Nut in below first figure, and do not fully tighten. Place the bracket under
the subframe's 3rd horizontal beam and using x4 10-32 x 1/2" RD Head Bolt, #10 Flat
Washer and #10 Lock Washer, secure and tighten bracket to subframe seen in the third
figure.
Step 8
Once all the brackets
and to the vehicle, tighten all the hardware, except the adjustable middle support bracket.
Once the subframe is fully
port bracket and tighten the last 2 pieces of hardware. Installation is complete.
Support bracket location on sub-
frame
tightened and secured, adjust the height of the middle sup-
of been mounted to the subframe
5
Advertisement
