Summary of Contents for D&R ELECTRONICS 933-0130A
- Page 1 Sub-Frame 2018 Expedition 933-0130A INSTALLATION MANUAL Contents: Parts List————--—-————--2 Installation Instructions———-—-2 Warranty & Product Return Policy-6...
-
Page 2: Parts/Hardware List
PARTS/HARDWARE LIST Quantity Part # Description 933-0130A 2018 Expedition MAX Subframe 401-0000 1/4-20 x 3/4” RD Head Bolt 403-0005A 1/4-20 Flat Washer 422-0009 1/4-20 Nyloc Nut 403-0004 1/4-20 Lock Washer 401-0053 10-32 x 1/2” RD Head Bolt 403-0007A #10 Flat Washer... - Page 3 Step 2 Install the back subframe support brackets (which will be located towards the front of the vehicle) using supplied vehicle factory hardware and 2 fender washers. Do not fully tighten brackets. (Brackets are symmetric and are not side specific). Step Fasten, but do not tighten middle brackets to subframe on left and right sides using 10-32 x 1/2”...
- Page 4 Step 5 Using 1/4-20 x 3/4” RD Head Bolt, 1/4-20 Flat Washer, and 1/4-20 Lock Washer, fasten the subframes rear mount brackets (installed in step 2) to the subframe. Do not fully tighten. Step 6 Using vehicle factory hardware and fender washer, install middle mount bracket to the vehicle but do not tighten fully to allow for adjustability.
- Page 5 Step 8 Using vehicle factory hardware install the subframe front mount brackets on the left and right side (located at the furthest rear of the vehicle) and do not fully tighten. Step 8 Assemble middle support bracket using x2 10-32 x 1/2” RD Head Bolt, #10 Flat Washer and #10 Nyloc Nut in below first figure, and do not fully tighten.
-
Page 6: Warranty
WARRANTY D & R Electronics warrants its new products to be free from defects in material and workmanship, un- der normal use and service, for a period of one year on parts replacement, and one year on labor. This warranty applies only to original purchasers acquiring the product directly from D&R Electronics, or its authorized dealers.