Table of Contents
Advertisement
Operating Instructions
Assembling the Canopy
When transporting the picking assistant be sure to remove the
canopy as it cannot withstand speeds over 15 MPH. Follow
these instructions to properly reassemble the canopy upon
arrival.
1.
Install the canopy frame brace (a). First, place a 15/16"
shaft collar (b) 2" from the end of the pipe as shown
(Figure 11). With the first shaft collar in place, slide the
canopy brace through the hole in the picking assistant
frame and place a second shaft collar (d) on the inside of
the frame tube to keep the canopy brace from pulling out.
Install the 2-1/2" square poly plug (c) on the end of the
frame tube as shown (Figure 11).
2.
Install the horizontal canopy pipes (a). First, place a
15/16" shaft collar (b) 29" from the end of the canopy
pipe as shown (Figure 12). With the first shaft collar
in place, slide the pipe through the hole in the vertical
canopy tube. Then place a second shaft collar on the
front side of the vertical canopy tube as shown.
3.
Install the front canopy end pipe (a) by inserting the pegs
into the horizontal canopy pipes (b). Be sure that the peg
also goes through the hole in the canopy frame brace (c)
as shown (Figure 13).
4.
Insert the top (larger) horizontal canopy pipe (a) over
the top peg on the front canopy end pipe (c) as shown
(Figure 14).
5.
Insert the rear canopy end pipe (b) into the three
horizontal canopy pipes as shown (Figure 14).
6.
Install the canopy (a) as shown with the logos facing out
to allow for proper water drainage (Figure 15).
7.
With the canopy in place, secure it to the canopy end
pipes and the horizontal canopy pipes using the ball
bungee straps (a) (Figure 16).
8.
Note: When you first place the canopy over the picking
assistant, secure it to the end pipes at the four corners
with ball bungee straps before moving on to fully secure
the canopy.
8
b
a
2"
c
d
Figure 11: Canopy frame brace
b
a
b
c
a
Figure 13: Front canopy end pipe
c
Figure 14: Rear canopy end pipe
a
Figure 16: Securing canopy with straps
29"
a
b
Figure 12: Horizontal canopy pipes
a
Figure 15: Canopy
b
a
Advertisement
Table of Contents
