Sony DNW-75 Installation Manual page 11

. Attaching the inner rails
4. Pull out the inner rails from the two intermediate rails.
5. While pressing the stopper of the inner rail in the
direction of the arrow A in the figure, pull inner rail
out in the direction of the arrow B.
Intermediate rail
Inner rail
Stopper
B
6. Remove the ten screws from both sides (left and right)
of the unit as shown in the figure below.
7. Attach the two inner rails to both sides (left and right)
of unit, with the removed screws in the step 6.
Tightening torque: 120 x 10
n
Be sure to use the (B4 x 6) screws when attaching the
inner rail. The use other-sized screws may cause a
malfunction of the unit.
Inner rail
B4 x 6
DNW-75/75P
DNW-65/65P
Outer rail
A
_2 N . m {12.2 kgf . cm}
Inner rail
B4 x 6
. Attaching the rack angles (handles)
8. Remove the four screws from both sides
(left and right) of the unit.
B4 x 6
B4 x 6
n
Keep these screws (B4 x 6).
Be sure to use these screws when directly fixing the
side panels without the rack angles.
The use of longer screws such as the screws (PSW 4 x
16) for fixing the rack angles will cause a malfunction
of the unit.
9. Attach the two rack angles to both sides (left and right)
of the unit with the supplied four screws (PSW4 x 16).
Tightening torque: 120 x 10
PSW4 x 16
Rack angle
PSW4 X 16
1-6. Rack Mounting
B4 x 6
B4 x 6
_2 N . m {12.2 kgf . cm}
Rack angle
PSW4 x 16
1-5