nbf Signature Series Assembly Instructions

Congratulations on the purchase of your new Signature Series chair!
PARTS
CHAIR BODY
QTY: 1
MID-BACK VERSION
HIGH-BACK VERSION
ARM RESTS
QTY: 2
WIDTH
ADJUSTABLE
KNOB QTY: 2
SEAT LIFT
QTY: 1
BASE
QTY: 1
CASTERS
QTY: 5
ALLEN WRENCH
SPARE PART
(SAVE FOR FUTURE
TIGHTENING)
CUSTOMER SERVICE HOTLINE
800-626-6060
A S S E M B LY I N S T R U C T I O N S
INSTRUCTIONS
Remove all parts from carton and verify part quantities as indicated on parts list.
1
Insert the caster into the hole at the bottom of the five prong base.
2
Insert the bottom end of the seat lift into the center hole of the base.
3
Place the chair body onto the small end of the seat lift.
4 Insert armrests into the holes located at both sides of the seat. Insert the width-adjustable
knobs into the holes from the underside of the seat. Adjust the width of the armrest to your
preference, and tighten securely.
Attention: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
1
3
Warnings
1. This product should be used by only one person at a time.
2. Do not use this chair unless all bolts, screws and knobs are securely tightened.
3. Save Allen wrench. Check that all bolts, screws and knobs are tight every three months or as needed.
4. Dispose of packing material properly. Do not use the plastic cover as a head covering.
It may cause suffocation.
5. Do not use the chair as a stepladder.
6. Use this chair for its intended purpose only.
7. Use a soft cloth to clean the chair. Do not use water or chemicals on the aluminum parts.
W W W. N B F. C O M
A R R I S C H A I R
2
4