Advertisement
5.
OPERATING INSTRUCTIONS
5.1.
Pre-use Inspection.
WARNING! INSPECT THE GRINDER BEFORE USE. ENSURE THE GRINDER IS UNPLUGGED FROM THE MAINS POWER
!
BEFORE COMMENCING THE INSPECTION.
5.1.1. Check the tool rests are securely fixed and are not more than 2mm from the grinding wheels.
5.1.2. Check that eye shields are in good condition, secure and that you can see through them clearly.
5.1.3. Turn the grinding wheels by hand and check for any damage. Check they do not touch the tool rests and are correctly aligned.
If any of the above checks fail, replace, repair, or adjust as necessary before starting the grinder.
5.2.
Wheel Use.
The grinder is supplied with two aluminium oxide wheels, one course and one fine. Fine is preferred for hard materials and coarse for soft
materials.
If the surface of the wheel becomes "loaded" (coated with particles of the material being ground) it is probably the wrong grade for the job.
Important reminder: Only a person holding a grinding wheel certificate may install wheels. See Section 4.
5.3.
Using the Grinder.
WARNING! Before commencing work, ensure you read, understand and apply the Section 1 Safety Instructions.
!
5.3.1. Plug grinder into the mains power supply.
5.3.2. Adjust the eyeshield to give maximum protection.
5.3.3. Switch on the grinder and bring the workpiece slowly into contact with the rotating wheel.
5.3.4. When the task is complete unplug the grinder from the mains power supply and clean the machine ready for next use.
6.
MAINTENANCE
WARNING! Ensure the grinder is unplugged from the mains power supply before performing any maintenance or service.
!
6.1.
As the grinding wheels wear, adjust the positions of the tool rests. Each rest must be set not more than 2mm from the grinding surface.
6.2.
Regularly remove the grinding wheel covers and clean out any dust and dirt.
6.3.
The machine motor and bearings are sealed units and require no regular maintenance. Should you require assistance, contact your
local service agent.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500.
Declaration of Conformity
following standards and directives
Bench Grinder 150mm
Model: BG150CX.V3
73/23/EEC LowVoltageDirective
2004/108/EC EMC Directive
2006/42/EEC Machinery Directive
93/68/EEC CE Marking Directive
2002/95/EC RoHS Directive
2002/96/EC WEEE Directive
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this equipment.
WARRANTY: Guarantee is 12 months from purchase date proof of which will be required for any claim.
INFORMATION: Call us for a copy of our latest catalogue and promotions on 01284 757525 and leave your full name and address including your postcode.
We, the sole importer into the UK, declare that the product listed here is in conformity with the
The construction file for this product is held by the Manufacturer and may be inspected, by a national
authority, upon request to Jack Sealey Ltd.
Signed by Mark Sweetman
For Jack Sealey Ltd Sole importer into the UK of Sealey Quality Machinery.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
16th August 2007
01284 757500
Web
01284 703534
email
www.sealey.co.uk
sales@sealey.co.uk
BG150CX.V3 - (1) - 160807
Advertisement
