Maintenance And Cleaning; Information About Recycling And Disposal; Ec Declaration Of Conformity - Parkside PMSG 200 A1 Operation And Safety Notes

... / Maintenance and cleaning / Information about recycling ... / EC Declaration ...
Burn
Weld seam width
Weld bead
Weld seam fault
z Maintenance and cleaning
The welding device must be
Note:
regularly serviced and overhauled for
proper function and for compliance
with the safety requirements. Improper
and wrong operation may cause fail-
ures and damage to the device. Repairs
must only be carried out by qualified
electricians.
Switch off the main power supply
„
and the main switch of the device
off prior to performing any mainte-
nance work on the welding device.
Clean the welding device and
„
accessories regularly using air,
cotton waste or a brush.
In case of a defect or a necessary
„
replacement of equipment parts,
please contact the appropriate
qualified personnel.
Push welding
smaller
larger
flatter
larger
z Information about
recycling and disposal
no longer functional should be recycled
wherever possible. Ask your local
stockist for advice. To do this, please
see 2012/19/EU.
z EC Declaration of
Conformity
We,
C. M. C. GmbH
Responsible for documentation:
Dr Christian Weyler
Katharina-Loth-Str. 15
66386 St. Ingbert
GERMANY
hereby take sole responsibility for
Drag welding
larger
smaller
higher
smaller
Don't throw away –
recycle!
Please return this device,
accessories and packaging to
your local recycling depot.
Do not dispose of the welding
device in household waste, in
fire or in water. Devices that are
GB/MT 83