Cisco 7204 Installing page 7

Figure 3-4 Installing the Chassis in a Telco-Type Rack
Warning To prevent the rack from tipping when installing the router in Telco-type racks,
ensure that the rack is bolted to the floor and, if necessary, anchored with appropriate
fixtures. To see translated versions of this warning, refer to the publication Regulatory
Compliance and Safety Information for the Cisco 7200 Series Routers (Document
Number 78-3419-xx) that accompanied your Cisco 7204.
To install the chassis in the rack, complete the following steps:
On the chassis, ensure that all captive screws on the network processing engine,
Step 1
the I/O controller, and each power supply are tightened and the port adapter
levers are in the locked position.
Rack-Mounting the Cisco 7204
Cisco 7200
SERIES
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
Installing the Cisco 7204 3-7