Clover Flex Manual

Charging your

Hide thumbs Also See for Flex:

Charging Your Clover Flex

For periods of infrequent use or for storing the Clover Flex we recommend fully

charging your device and powering off. You should repeat this every 6 - 9

months. These steps are important, because a fully charged primary battery will

protect your device with tamper detection for about 1 year.

If the primary battery becomes fully discharged, the backup battery will maintain

tamper detection for around 3 months. After 3 months, your Flex will enter into

a tampered state and stop functioning altogether.

To connect to power and charge your Clover Flex, then power off:

1. Holding the charging cradle upside down, firmly insert the power cord

into the charging input.

2. Thread the cord across and out the back.

3. Insert the power cord into the charging brick.

4. Plug in the other end of the power cord to a power outlet.

Table of Contents

Need help?

Do you have a question about the Flex and is the answer not in the manual?

Page 1 Charging Your Clover Flex For periods of infrequent use or for storing the Clover Flex we recommend fully charging your device and powering off. You should repeat this every 6 - 9 months. These steps are important, because a fully charged primary battery will protect your device with tamper detection for about 1 year.
Page 2 Best, Clover Team © 2020 Clover Network, Inc. All rights reserved. The Clover® name and logo are trademarks owned by Clover Network, Inc., a wholly owned subsidiary of First Data Corporation, and registered or used in the U.S., Europe, and other countries.