Turning The Device On And Off; Insert / Remove Sd-Card - Naneos Partector Operation Manual

www.naneos.ch

Turning the device on and off

To turn the device on, press the power button. To turn it off, press and
hold the power button for two seconds and release it when the goodbye
message appears.
Insert / remove SD-card
To store data on the microSD-card, insert it in the partector as shown in
the graph till it snaps in.
To remove the SD-card, press on the inserted card which will force the
release. To insert the card in your SD-card slot on a PC you need to insert
the card first in the SD/SD-card adapter or SD/USB adapter provided.
Figure 2a: Inserting
the SD-card
Recording measurements on the SD-card
If a SD-card is inserted in the partector at startup, the device
automatically starts recording on the SD-card when the device is turned
on. It automatically generates a filename depending on start date, time
and device serial. For more information about this, read the "partector data
file" section.
If you insert the SD-card while the device is running, the data
logging will not start automatically. You need to turn the device
on after inserting the card.
Do not remove the SD-card while the device is running. The
data file needs to be closed properly, otherwise it will be
corrupt.
Figure 2b: Inserting the SD-
card into the adapter
7 | 17